72A-1898 Rev. A 11/01 4-1
Monday, November 26, 2001 1:09 pm
4. Setup and Operation
This chapter contains sections that discuss the following:
• Safety recommendations for use with the TDR9000
• Site preparation, including:
• Setting up the circuit breakers being tested
• Configuring the TDR9000 Test Plan
• Configuring TDR9000 connections
• Running a test
This chapter also discusses test safety recommendations, wiring, and
running First Trip/Close tests. Since First Trip tests require that the circuit
breaker be energized, references to discussions of test setup are found in
”First Trip/Close Tests”. Once test setup is complete, move to ”Using the
Pretest Checklist” on page 4-70 and proceed with the rest of the chapter
to run the test and disconnect after the test is complete.
First Trip/Close Tests
Specific discussions for First Trip/Close tests occur in the following
places:
• ”Safety Considerations: First Trip/Close Tests” on page 4-2
• ”First Trip/Close Virtual Front Panel Configuration” on page 4-2
• ”Configuring Analog/Auxiliary Channels for First Trip/Close Tests”
on page 4-4
• ”Running a First Trip/Close Test: Special Considerations”
on page 4-75
• ”Disconnecting After a First Trip/Close Test” on page 4-101
To Next Page
Loading...
