doble TDR9000 - Step 4: Laptop and TDR9000 Test Plan Configuration

TDR9000
™
Circuit Breaker Test System User’s Guide
72A-1898 Rev. A 11/01 1-15
Monday, November 26, 2001 1:09 pm
For the TR3190 Digital Rotary/Linear Transducer:
• Rotary Motion setup, refer to ”Rotary Motion” on page 4-18.
• Linear Motion setup, refer to ”Linear Motion” on page 4-24.
For the TR3160:
• Linear Transducer setup, refer to ”Linear Motion” on page 4-24.
• Motion Transducer Rotary setup, including the TR3165 Rotary
Adapter, refer to ”Rotary Motion” on page 4-24.
Step 4: Laptop and TDR9000
™
Test Plan Configuration
Figure 1.11 shows how the TDR9000 looks once the laptop is set up,
Figure 1.12 on page 1-17 shows a partial TRXField
™
Test Plan, and
Figure 1.13 on page 1-18 shows the Virtual Front Panel once the
software is configured.
Preparation of the TDR9000 includes the following sub-steps:
1. Connect the laptop to the serial port of the TDR9000, power up
the laptop and the TDR9000, and run the TRXField™ software.
Refer to ”Connecting to the Laptop, Printer and Powering Up”
on page 4-27.
2. Import a Test Plan from TRX™ or configure a new one.
Refer to ”Connecting the TDR9000™ Physical Front Panel”
on page 4-30.
3. Configure the Virtual Front Panel.
Refer to ”Setting Up a Test Plan Manually with TRXField™”
on page 4-43.