G-6 72A-1898 Rev. A 11/01
Monday, November 26, 2001 1:09 pm
Signal error on trip output during
test run. This indicates a problem
with the trip/close module.
See ”Test Exceptions Procedure”.
Signal error on close output
during test run. This indicates a
problem with the trip/close
module.
See ”Test Exceptions Procedure”.
Power supply failure during test
run.
Run Self-Diagnostics (see
”Self-Diagnostics Test”
on page B-1).
Trigger overload during test run. See ”Test Exceptions Procedure”.
Trip module relay closed before
power applied during test run.
This indicates a problem with the
trip/close module.
See ”Test Exceptions Procedure”.
Close module relay closed before
power applied during test run.
This indicates a problem with the
trip/close module.
See ”Test Exceptions Procedure”.
Trip module relay opened after
power applied during test run.
This indicates a problem with the
trip/close module.
See ”Test Exceptions Procedure”.
Close module relay opened after
power applied during test run.
This indicates a problem with the
trip/close module.
See ”Test Exceptions Procedure”.
Table G.5 Test Exceptions (Continued)
Error Message Solution
To Next Page
