EasyManuals Logo

Edge-Core ECS4620-28F User Manual

Edge-Core ECS4620-28F
2143 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #78 background imageLoading...
Page #78 background image
Chapter 2
| Using the Web Interface
Navigating the Web Browser Interface
– 72 –
Show Link Trace Cache Shows information about link trace operations launched from this
device
521
Show Fault Notification Generator Displays configuration settings for the fault notification generator 522
Show Continuity Check Error Displays CFM continuity check errors logged on this device 523
OAM Operation, Administration, and Maintenance 524
Interface Enables OAM on specified port, sets the mode to active or passive, and
enables the reporting of critical events or errored frame events
524
Counters Displays statistics on OAM PDUs 527
Event Log Displays the log for recorded link events 528
Remote Interface Displays information about attached OAM-enabled devices 529
Remote Loopback Performs a loopback test on the specified port 530
UDLD UniDirectional Link Detection 533
Configure Global Configures the message probe interval, detection interval, and recovery
interval
534
Configure Interface Enables UDLD and aggressive mode which reduces the shut-down
delay after loss of bidirectional connectivity is detected
535
Show Information Displays UDLD neighbor information, including neighbor state,
expiration time, and protocol intervals
537
IP 619
General
Routing Interface
Add Address Configures an IP interface for a VLAN 619
Configure Interface Submits a DHCP request for additional information from a VLAN
interface configured with a static IPv4 address
623
Show Address Shows the IP interfaces assigned to a VLAN 619
Ping Sends ICMP echo request packets to another node on the network 673
Trace Route Shows the route packets take to the specified
destination
674
ARP Address Resolution Protocol 676
Configure General Sets the aging time for dynamic entries in the ARP cache 676
Configure Static Address 678
Add Statically maps a physical address to an IP address 678
Show Shows the MAC to IP address static table 678
Show Information Shows entries in the Address Resolution Protocol (ARP) cache
Dynamic Address Shows dynamically learned entries in the IP routing table 680
Other Address Shows internal addresses used by the switch 680
Statistics Shows statistics on ARP requests sent and received 680
Table 4: Switch Main Menu (Continued)
Menu Description Page

Table of Contents

Other manuals for Edge-Core ECS4620-28F

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Edge-Core ECS4620-28F and is the answer not in the manual?

Edge-Core ECS4620-28F Specifications

General IconGeneral
BrandEdge-Core
ModelECS4620-28F
CategorySwitch
LanguageEnglish

Related product manuals