Chapter 2
| Using the Web Interface
Navigating the Web Browser Interface
– 73 –
Routing
Static Routes 681
Add Configures static routing entries 681
Show Shows static routing entries 681
Routing Table
Show Information Shows all routing entries, including local, static and dynamic routes 683
Configure ECMP Number Sets the maximum number of equal-cost paths to the same destination
that can be installed in the routing table
684
VRRP Virtual Router Redundancy Protocol 687
Configure Group ID 688
Add Adds a VRRP group identifier to a VLAN 688
Show Shows the VRRP group identifier list 688
Add IP Address Sets a virtual interface address for a VRRP group 688
Show IP Addresses Shows the virtual interface address assigned to a VRRP group 688
Configure Detail Configure detailed settings, such as advertisement interval,
preemption, priority, and authentication
688
Show Statistics
Global Statistics Displays global statistics for VRRP protocol packet
errors
694
Group Statistics Displays statistics for VRRP protocol events and errors on the specified
VRRP group and interface
695
IPv6 Configuration 624
Configure Global Sets an IPv6 default gateway for traffic with no known next hop 625
Configure Interface Configures IPv6 interface address using auto-configuration or link-local
address, and sets related protocol settings
626
Add IPv6 Address Adds an global unicast, EUI-64, or link-local IPv6 address to an interface 630
Show IPv6 Address Show the IPv6 addresses assigned to an interface 632
Show IPv6 Neighbor Cache Displays information in the IPv6 neighbor discovery cache 634
Show Statistics 635
IPv6 Shows statistics about IPv6 traffic 635
ICMPv6 Shows statistics about ICMPv6 messages 635
UDP Shows statistics about UDP messages 635
Show MTU Shows the maximum transmission unit (MTU) cache for destinations
that have returned an ICMP packet-too-big message along with an
acceptable MTU to this switch
641
Table 4: Switch Main Menu (Continued)
Menu Description Page
To Next Page
Loading...
Need help?
General