87
(4) Press the page down button to go to PAGE3. The edge color can be set on this page. Turn
F4 to select a color among eight standard colors. If you wish to use a color other than those
eight, adjust the color by turning F1, F2 and/or F3.
KEY1 : EDGE COLOR :RECALL : 3/3
EDGE COL:S=0.0 L=0.0 H=0.0 : >BLACK:
10-9. Where DSKs Appear
The DSK images appear on the P/P program screen as a factory default setting. Users can
change the destination of DSKs to M/E or AUX1-8. To do this, follow the procedure below.
(1) Press the MENU control button and then the SETUP button on the SELECT/KEYPAD block
to display the [SETUP] menu.
(2) Turn F1 to select FUNCTION, and press F1 or the page down button to open the [SETUP –
FUNCTION] menu.
(3) Turn F1 to select KEY/DSK, and press F1 or the page down button to open the [SETUP
–FUNCTION-KEY/DSK] menu.
SETUP :>KEY/DSK >VIRTUAL >AUX LINK>3D
FUNCTION:
4) To display the DSK1 image on the M/E program video, turn F1 to select M/E and then press
F1. Select the destination for DSK2 to DSK4 in the same way.
FUNCTION: DSK1 : DSK2 : DSK3 : DSK4 : 1/2
DSK ASGN: =M/E : =P/P : =P/P : =P/P :
To Next Page
