194
Uploading Images to the Switcher
(1) Open the folder where your images are stored.
(2) Select the image to be uploaded and drag and drop it to STILL1 (or STILL2 to STILL4)
folder of the FTP server shown in Internet Explorer. It takes about 1 minute to complete
receiving data. Then display the STILL1 (or STILL2) image in the monitor by operating the
switcher to check that the still image is properly sent.
Downloading Still Images from the Switcher
Open the STILL1 (or STILL2 to STILL4) folder of the FTP server using Internet Explorer.
Select an image file to be downloaded. Drag and drop it to any folder of your computer.
29-3-3. Sending Images to Clip Memory
Preparation
(1) Prepare sequential image files in the following name format.
File name: [STILLXXX.yyy]
XXX: Indicates Serial numbers. Available from 000 to 059
yyy: Indicates a file extension. bmp, jpg or bmp
(2) Connect the PC to the Main Unit, referring to section 28-3-2 (1) to (6).
Uploading Sequential Images to Clip Memory in the switcher
(1) Open the folder on the PC, in which sequential files are stored.
(2) Select all sequential files to be uploaded and drag and drop them to the root folder of the
FTP server shown in Internet Explorer. Data of 60 image files can be transferred in about
5 minutes.
To Next Page
