27
4-3. Copying / Swaping Settings
DSK, keyer and PinP can be set up easier with this feature by copying settings from PinP1 to
PinP2, swapping settings between PinP1 and PinP2, or copying settings from KEY1 to KEY2 or
DSK.
4-3-1. Operation Example: Copying Settings from KEY2 to DSK1
(1) Press the COPY/SWAP button in the SELECT/KEY PAD CONTROL. The button's light
turns on and the COPY SWAP menu is displayed (see "DIRECT ON/OFF" and "XPT
ON/OFF.") and available buttons on the keypad turns on green.
(2) Press the COPY button. (Press SWAP if you want to swap settings.)
(3) Press KEY2 to copy the settings. The button will light up orange.
(4) Press DSK1 to set the destination bus. The button will light up orange.
(5) Press ENTER to paste the settings to DSK1. To cancel the process, press COPY/SWAP.
(If DIRECT mode is ON, copy and paste are performed without pressing ENTER. See
"DIRECT ON/OFF" below.)
Copying and swapping settings are available among KEY1, KEY2 and DSK1 to 4. However,
keyer's additional features such as Wipe and Chromakey are not copied or swapped.
Copying and swapping settings are also possible between PinP1 and PinP2.
DIRECT ON/OFF
If DIRECT is set to ON, copy and paste are performed without pressing ENTER.
COPY/ :DIRECT : :XPT : :1/1
SWAP : =OFF : :=--- : :
XPT ON/OFF
If XPT is set to ON, the signal selections such as key source and insert signal settings are
also copied to or swapped between.
SELECT / KEYPAD
MEMORY
CONTROL
WIPE
MENU
INC
DEC
+/-
PLAY
STOP
CLEAR
2D DVE
USER BUTTON
7
4
1
CUT
0
COPY
EVENT
COPY/SWAP
8
SWAPCOPY
5
RECALL
PASTE
SEQUENCE
SEQ EDIT
9
NEW
6
INS
3
ADD
STORE
ENTER
OVWR
SETUP STILL MATT FILE
KEY1 KEY2 P IN P1 P IN P2
DSK1 DSK2 DSK3 DSK4
WIPE
2
DEL
(1)
(3)
(4)
(2)
(5)
To Next Page
Loading...
Need help?
General
