131
18-1-4. Playing Back Sequences Using Advanced Settings
Playing Sequences by Changing Bus Signal Selections
Sequence data includes that on bus signal selection states and are basically recalled on the
control panel exactly the same that they were stored. For example, if Bus Button 1 was
selected in the M/E PGM bus and Bus Button 2 in the M/E PST bus in the sequence, these
buttons should be selected in the same way when recalling the sequence.
However, users can select 5 in the PGM and 6 in the PST when recalling the sequence.
To do this, follow the procedure below.
(1) Press SEQUENCE to display the [SEQUENCE MEMORY] menu.
(2) Press 0 to select "Sequence Memory 0."
(3) Press RECALL to recall the data that was stored in "Sequence Memory 0" to the working
memory.
(4) Press SEQ EDIT to display the [SEQ EDIT] menu.
(5) Press the page down button twice to go to PAGE3.
(6) Turn F1 to select ALL (all buses) or M/E BG.
(7) Turn F2 to set XPT to OFF.
SEQ EDIT:SELECT : XPT : TRANS :INTERP : 3/3
CTRL ENA: =ALL : =OFF : =AUTO : =LINE :
(8) Press 5 in the M/E PGM row and press 6 in the M/E PST row.
(9) Press +/- (PLAY) to play back the sequence.
Playing Sequences without Specific Bus(es) or Using Manual Transitions
The sequences can be played back without DSK1 and by using manual transitions for DSK2.
To do this, follow the procedure below.
(1) Open PAGE3 in the [SEQ EDIT] menu.
(2) Set SELECT to DSK1 and TRANS to OFF.
SEQ EDIT:SELECT : XPT : TRANS :INTERP : 3/3
CTRL ENA: =DSK1 : =OFF : =OFF : =LINE :
(3) Set SELECT to DSK2 and TRANS to MANU.
SEQ EDIT:SELECT : XPT : TRANS :INTERP : 3/3
CTRL ENA: =DSK2 : =OFF : =MANU : =LINE :
OFF The selected bus is not played back.
AUTO (default setting) The selected bus is automatically played back.
MANU (manual)
The transition for the selected bus should be performed manually by
using the fader lever or the AUTO button.
Note that even if AUTO or MANU is set for a bus at TRANS, it cannot be performed if the
Fader Link of the bus is set to ON.
To Next Page
Loading...
Need help?
General
