132
Playing Sequences Using the Fader Lever
The playback of sequences can be played back using the fader lever. To do this, follow the
procedure below.
(1) Open PAGE1 in the [SEQ EDIT] menu.
(2) Set LINK to ON.
SEQ EDIT: LOOP : DIR : LINK :TOTAL-D: 1/3
PLAY : =ON : =NOR : =ON : =100 :
(3) Move the fader lever from end to end to play the sequence one time with the desired play
time.
Note that if AUTO or MANU is set for a bus at TRANS, it cannot be performed if the Fader
Link of the bus is set to M/E or P/P. Even if LOOP is set to ON, the looping playback cannot
be performed if the Fader Link of the bus is set to M/E or P/P.
Playing Sequences with the Fader Lever or the PLAY Button Using the Break Function
The Break function can automatically pause sequence playback at a desired step. The
setting example below shows how to set the Break function at Step2 and how to play back
the sequence with the AUTO button using the Break function.
(1) Open PAGE2 in the [SEQ EDIT] menu.
(2) Select 2 at STEP.
(3) Set BREAK to ON.
(4) Set BRK CTL to EACH.
SEQ EDIT: STEP : DUR : BREAK :BRK CTL: 2/3
STEP : = 2/ 3: =30 : =ON : =EACH :
BRK CTL setting BREAK setting Description
OFF --- The Break function is disabled at all steps.
EACH
OFF The Break function is disabled at this step
ON The Break function is enabled at this step.
ALL --- The Break function is enabled at all steps.
(5) Open PAGE1 in the [SEQ EDIT] menu and set LINK to M/E or P/P.
SEQ EDIT: LOOP : DIR : LINK :TOTAL-D: 1/3
PLAY : =ON : =NORML: =M/E : =60 :
(6) Press +/- (PLAY) to start the sequence playback. The sequence will stop at Step2. Press
+/- (PLAY) again to restart the sequence. The sequence will be played back from Step2 to
the end. The sequence playback with break points is also performed with the fader lever in
the same way.
First playback Second
playback
To Next Page
Loading...
Need help?
General
