139
Item Description Refer to
INC (INCREMENT)
DEC (DECREMENT)
Moves between steps. 18-1-5
18-1-6
PLAY Plays back a sequence.
Pressing the button during playback pauses the playback.
18-1-2
STOP Stops sequence play. 18-1-2
NEW Creates a new sequence by clearing the working memory
data.
18-1-1
18-1-5
INS Adds a step to the sequence. The step is inserted at the mid
point between the edit point (current position) and the next
step.
18-1-5
ADD Adds a step to the sequence. The step is added after the
edit point (current position) and the total duration is
increased.
18-1-1
18-1-5
OVWR
(OVERWRITE)
Overwrites the current step (where the edit point is placed)
with the data in the working memory.
18-1-5
CUT Deletes a step while keeping the intervals in front and back
of the step.
18-1-6
DEL Deletes a step by closing the intervals in front and back of
the step.
18-1-6
COPY
PASTE
Used to copy and paste step data.
To copy and paste steps, press COPY at the step to be
copied, move to the step in front of which the copied step is
to be inserted, then press PASTE.
18-1-6
The SEQUENCE EDIT menu
SEQ EDIT: LOOP : DIR : LINK :TOTAL-D: 1/3
PLAY : =OFF : =NORML: =OFF : =100 :
SEQ EDIT: STEP : DUR : BREAK :BRK CTL: 2/3
STEP : = 1/ 5: =30 : =OFF : =OFF :
SEQ EDIT:SELECT : XPT : TRANS :INTERP : 3/3
CTRL ENA: =ALL : =ON : =AUTO : =LINE :
Item Description Refer to
LOOP Sets Loop play ON or OFF. 18-1-2
DIR Selects the direction of playback between Normal and Reverse.
LINK Sets whether sequences are played back with the fader lever or
not. If set to M/E or P/P, sequence playback can be performed
with the fader lever.
18-1-4
TOTAL-D Sets total duration of the sequence. 18-1-7
STEP Specifies the current position (step) in the sequence.
Users can also move between steps by pressing INC and DEC
in the Keypad.
DUR Sets the duration of the current step.
BREAK Enables or disables the Break point on each step. 18-1-4
BRK CTL Enables or disables the Break function.
It can set the break point on all steps.
SELECT
XPT
TRANS
INTERP
Sets the signal selection and the interpolation mode for each
bus or all buses (M/E BG, P/P BKGD, KEY1-2, DSK1-4 and
PinP1-2).
18-1-4
18-1-7
To Next Page
Loading...
