GE LOGIQ P5 Service Manual

GE HEALTHCARE
DIRECTION 5394141, REVISION 5 LOGIQ™ P5 SEVICE MANUAL
8-146 Section 8-4 - Software Installation
8-4-3 Installing Application Software (cont’d)
10.)After the installation is completed the system will power off automatically.
NOTE: Some of systems doesn’t power off automatically. In this case, press and hold power button
more than 5 sec. to power off.
NOTE: Do not operate with using mouse or keyboard during installation procedures.
11.)Turn on the system and immediately eject the button on the DVD drive to eject the DVDROM Verify
that the system boots up no error.(It will take a few minutes)
NOTE: The application installation is completed, reboot is required.
12.)Shut down the system.
13.)Start the system
Figure 8-201 Installation Complete Message

GE LOGIQ P5 Specifications

General

Power Supply	100-240VAC, 50/60Hz
Display	15" LCD
Doppler Modes	Color Doppler, Power Doppler
Imaging Modes	B-Mode, M-Mode
Probes	Convex, Linear, Phased Array
Applications	Abdominal, Vascular, Cardiac, OB/GYN, Small Parts, Musculoskeletal
Connectivity	DICOM, USB, Ethernet
Probe Connectors	3
Portability	Mobile
Operating Temperature	10°C to 40°C
Relative Humidity	30%