GE LOGIQ P5 Service Manual

GE HEALTHCARE
DIRECTION 5394141, REVISION 5 LOGIQ™ P5 SEVICE MANUAL
Section 3-10 - Insite IP Address Configuration 3-25
Section 3-10
Insite IP Address Configuration
This information needed to facilitate the OnLine Center engineers in connecting to the system is found
in the InSite Installation Manual.
Section 3-11
Loading Base System Software
3-11-1 Loading Base system Software
For more information on loading base system software, refer to Chapter 8.
Section 3-12
Warnings
3-12-1 Warnings
3-12-1-1 USB HDD
External USB type Hard drive may be used to back up the data. But not all kinds of USB type can
be supported.
Never use USB types which require additional power source.
3-12-1-2 Starting Echoloader in Maintenance mode
If Echoloader never started once, starting Echoloader in the maintenance mode will not work. In
other words, in order to be able to start Echoloader in maintenace mode, Echoloader should have
been started at least once.

GE LOGIQ P5 Specifications

General

Power Supply	100-240VAC, 50/60Hz
Display	15" LCD
Doppler Modes	Color Doppler, Power Doppler
Imaging Modes	B-Mode, M-Mode
Probes	Convex, Linear, Phased Array
Applications	Abdominal, Vascular, Cardiac, OB/GYN, Small Parts, Musculoskeletal
Connectivity	DICOM, USB, Ethernet
Probe Connectors	3
Portability	Mobile
Operating Temperature	10°C to 40°C
Relative Humidity	30%