Work with Orders
If Then
You manually entered patient data in the
Patient Information screen after starting the
test
There is a data mismatch between the order
data and the manually entered patient data.
A warning message displays indicating a
mismatch in the patient name or patient ID
and asks you to confirm that the selected
order can be attached to the patient test,
overwriting existing patient data. Go to the
step 3.
3. Select Yes to update the patient information with data from the order. The order
is attached to the patient report.
• All patient demographic fields included in the order are populated in the test,
overwriting the existing patient data.
• The status of the order is changed to Attached.
4. Update test demographics in the Patient Information screen and select Save.
For more information, see Enter or Edit Patient Information Using the Software
Keyboard on page 59.
Attach an Order that is Attached to a Different Patient Test
NOTE:
Only one patient test can be associated with an order at any given time,
regardless of the status of the patient test.
1. Start a new patient test.
2. Double-tap an order attached to a patient test in the Orders list.
A message displays indicating that the order is already attached to a patient
test.
3. Perform one of the actions below:
• Select Detach to detach the order from the existing patient test and attach
the order to the new patient test.
If Then
The patient test the order
is attached to is already
transmitted to its default
destination
The order cannot be removed from this test.
A message displays indicating that the patient test has
been transmitted to the default destination and the order
cannot be detached.
Select OK.
If the patient test is not
transmitted
A message displays notifying you that the order will be
detached from the patient test.
Go to step 4.
5864335-001-1  MAC
â„¢
5 A4/MAC
â„¢
5 A5/MAC
â„¢
5 Lite 103
To Next Page
Loading...
Need help?
General
