Configure the MUSE System for Network Communication
NOTE:
To make changes to the configuration you may need to use Run as
Administrator.
2. Review the protocol(s) that you are using to communicate with MUSEAPI3 and
modify as appropriate.
You can select more than one protocol.
You are advised to use the port values below:
Protocol Recommended Port Values
HTTP 8100
HTTPS The port for SSL, as configured by the customer.
net.tcp 8101
NOTE:
For more information on the available communication protocols, see Table
116: MUSEAPI3 Installation Prerequisites on page 312.
3. Determine whether you want to select PID Search: Combined Test Lists to
change the Patient Conflict behavior of the MUSEAPI3 and do one of the steps
below:
• Select to enable the PID Search: Combined Test List. When performing
a Patient ID search while this option is enabled, MUSEAPI3 automatically
combines all tests for that Patient ID for the same MUSE site, even if there is a
Patient ID/Last Name mismatch.
• To disable the PID Search: Combined Test List, leave the box unselected.
When performing a Patient ID search while this option is disabled, MUSEAPI3
includes patient conflicts if there is a Patient ID/Last Name mismatch within
the same site.
This setting can always be changed later.
NOTE:
MUSEAPI v3.1 handles patient conflicts within the same MUSE site differently
than MUSEAPI v3.0. MUSEAPI v3.1 only provides a response that includes
patient conflicts if there is a Patient ID / Last Name mismatch, and that
conflict response can be disabled by enabling this option. MUSEAPI v3.1
handles patient ID conflicts across different servers or at different sites the
same as MUSEAPI v3.0.
4. If any changes were made, restart the MUSEAPI3 service.
Uninstall MUSEAPI3
If you are going to reinstall MUSEAPI3 at a later date, it is recommended that you
copy the MUSEAPIService.exe.config file located in the MUSE installation folder,
and save it to a location outside of the MUSE installation folder. This file contains
324 MAC
™
5 A4/MAC
™
5 A5/MAC
™
5 Lite 5864335-001-1