Record an ECG or Rhythm
Edit Patient Information in a Patient Report
Make sure that you have the privilege to edit patient reports.
After a test is acquired, you can edit patient information using the software keyboard
or by attaching an order. When an order is attached to a patient test, some fields are
read-only.
If you try to edit or attach an order to a patient report that is transmitted to the
default destination, an error message displays.
You cannot edit patient information by scanning a patient barcode, selecting a
patient record from the Patients list, or performing ADT queries.
WARNING:
INACCURATE PATIENT DATA - Incorrect patient information can cause patient
data mismatch. Data assigned to the wrong patient causes erroneous patient
data that can affect diagnosis and treatment.
Be sure to check the patient information screen for each new patient. Make
sure that you enter patient data for the correct patient.
1. To edit patient information for the patient report, select the Edit icon in the
Report Review page in the Acquisition screen:
The Patient Information screen opens.
2. Edit the patient information using a software keyboard. See Enter or Edit Patient
Information Using the Software Keyboard on page 59.
3. Select Save to save your changes for this patient and collapse the screen.
If you select any other icons at the bottom of the tab prior to saving, the Patient
Information screen collapses and the edited patient information is saved.
The updated patient information displays on the patient report.
Delete a Patient Report
Make sure that you have the privilege to delete Rhythm, Full Disclosure, or ECG
patient reports.
NOTE:
If you do not have the privilege to view patient reports, but you have the
privilege to delete patient reports, you can only view and delete patient
reports you created in the current session.
5864335-001-1  MAC
â„¢
5 A4/MAC
â„¢
5 A5/MAC
â„¢
5 Lite 87
To Next Page
Loading...
Need help?
General
