GE MAC 5 A4 User Manual

Configure the MUSE System for Network Communication
netsh http show sslcert
NOTE:
IF the SSL Certificate bindings were entered incorrectly, the SSL Certificate
bindings must be deleted and recreated using the commands below:
netsh http delete sslcert ipport=0.0.0.0:(port
assigned for MUSEAPI3 HTTPS protocol)
netsh http delete sslcert ipport=[::]:(port assigned
for MUSEAPI3 HTTPS protocol)
After deleting the bindings they can be re-created using the information in
step 9.
Set Up DCP Inbound Communication for MUSE v8.x or v9.x
Use the procedures below to set up a MUSE v8.x or v9.x server for DCP
communication.
Verify that the MUSE DCP Inbound service and DCP Communication options are
installed and perform one of the steps below:
• If the options are not installed, go to Add the DCP Service and DCP Communication
Option to the MUSE System on page 328.
• If the options are installed, go to Set Up the DCP Server Configuration in the MUSE
System on page 329.
NOTE:
Installation of the DCP services restarts all MUSE services. If the MUSE system
is currently in use, before installing the DCP services, perform an Automatic
Shutdown of the MUSE system to notify MUSE users that the system is shutting
down.
Add the DCP Service and DCP Communication Option to the MUSE System
Use the procedures below to verify, and if necessary, add the MUSE DCP services and
DCP communication option to the MUSE system.
1. Log on to the MUSE application server as an administrator.
2. Select Control Panel> Add or Remove Programs or Programs and Features.
3. Select MUSE 8.x or MUSE 9.x and click Change.
The Welcome window opens.
4. Choose Modify and click Next.
The Select Features window opens.
5. Go to Server> Services.
6. Verify that DCP is selected.
328  MAC
™
5 A4/MAC
™
5 A5/MAC
™
5 Lite 5864335-001-1

GE MAC 5 A4 Specifications

General

Brand	GE
Model	MAC 5 A4
Category	Measuring Instruments
Language	English