Configure Settings
e) Select a valid client public key from the USB flash drive.
f) Select Install to install the selected client private and public keys.
The Install button is enabled only after you select client private and public
keys.
• If the installation is successful, the Certificate name, Issuing Authority,
Validity Dates, and Issuing Subject details display in the Currently
Installed Certificate Details section.
• If the installation fails due to an error, you need to troubleshoot the error.
See Wireless Network Connectivity Errors on page 284 and Errors while
Installing Certificates on page 283.
6. Perform the steps below to replace or delete the currently installed CA certificate
or client public and private keys:
a) Select the tab (CA Certificate, Client Private Key or Client Public Key)
where you want to replace or delete the installed certificate or key.
The currently installed certificate or key displays.
b) Select Delete.
A message displays asking you to confirm the deletion of the certificate or
key.
NOTE:
If you delete the client private key, the client public key is deleted and
vice versa.
c) Select OK. The certificate or key is deleted.
• If you want to replace the CA certificate, perform step 4.
• If you want to replace the client private and public keys, perform step 5.
Intermediate Certificates
If your site uses intermediate certificates, you may need to install both the
intermediate and the root certificates. Use the steps below to install the intermediate
and the root certificates.
1. Select Settings > Network > Wireless Network.
2. In the Wireless Network section, select Install Certificate.
The Install Certificate screen opens. By default, the CA Certificate tab is
selected.
242  MAC
â„¢
5 A4/MAC
â„¢
5 A5/MAC
â„¢
5 Lite 5864335-001-1
To Next Page
Loading...
Need help?
General
