Configure Settings
Field Action Description
Account
lockout
duration (min)
Select a value
from the drop-
down list to set
the duration
(in minutes) for
account to be
locked.
This specifies to configure the duration in minutes to
lock the account.
If it is set to one minute then the account will be locked
for one minute. You cannot log in for the next one
minute.
Default value: 1
Allowed values: 1 to 120
Lower
Alphabets
Enable or disable
this setting.
If this setting is enabled, the lower alphabet characters
are required to be used in the password.
If this setting is disabled, the lower alphabet characters
are not required to be used in the password.
Default value: Enabled
Numeric Enable or disable
this setting.
If this setting is enabled, the numeric characters are
required to be used in the password.
If this setting is disabled, the numeric characters are not
required to be used in the password.
Default value: Enabled
Upper
Alphabets
Enable or disable
this setting.
If this setting is enabled, the upper alphabet characters
are required to be used in the password.
If this setting is disabled, the upper alphabet characters
are not required to be used in the password.
Default value: Enabled
Special
Characters
Enable or disable
this setting.
If this setting is enabled, the special characters are
required to be used in the password.
If this setting is disabled, the special characters are not
required to be used in the password.
Default value: Enabled
Auto-Lock Enable or disable
this setting.
If this setting is enabled, the device is automatically
locked after a configured duration of inactivity.
If this setting is disabled, the device is not locked
automatically.
Default value: Enabled
Inactivity
Duration for
Autolock (min)
Enter the duration
of inactivity
(in minutes)
after which the
system must be
automatically
locked, if the
Auto-Lock setting
is enabled,
Default value: 15
Allowed values: 1 to 60
3. Select Save.
5864335-001-1  MAC
â„¢
5 A4/MAC
â„¢
5 A5/MAC
â„¢
5 Lite 205
To Next Page
Loading...
Need help?
General
