Configure the MUSE System for Network Communication
12. Click Next.
The MUSE API Configuration Tool window opens.
13. In the End Point Configuration area of the window, select the protocol(s) you are
using to communicate with MUSEAPI3 and enter the port value(s).
You must have at least one protocol enabled, and you may have more than one.
If any protocols are selected that you do not want, remove the check mark.
You are advised to use the values below for the ports:
Protocol Recommended Port Values
HTTP 8100
HTTPS The port for SSL, as configured by the customer.
net.tcp 8101
NOTE:
For more information on the available communication protocols, see Table
116: MUSEAPI3 Installation Prerequisites on page 312.
14. Click Save & Exit to save the changes to the End Point Configuration.
The InstallShield Wizard Complete window opens.
5864335-001-1  MAC
â„¢
5 A4/MAC
â„¢
5 A5/MAC
â„¢
5 Lite 317
To Next Page
Loading...
Need help?
General
