224 KAYENNE — User Manual
Section 3 — System Operation
Note Corner Pinning and Crops have their own path controls, however each corner
and each crop edge share the same path. See the
Kayenne User Manual
for more information about paths.
Figure 152. MFM—iDPM, CPin (Corner Pinning)
The use of the All and corner buttons:
T/L—Top Left,
T/R—Top Right,
B/L—Bottom Left, and
B/R—Bottom Right,
are the same as in the Corner Pinning menu (see Corner Pinning Menu on
page 219). The MFM soft knobs are used for adjusting the corners when
selected.
The Thru button performs the same function as the View Thru Enable button in
the menu but is momentary (opacity setting is only visible when the button
is held down). The opacity is adjusted with the
Thru soft knob (Figure 152).
Crop is available in the CPin menu. When Corner Pinning is enabled, and
the
Crop button is pressed, the All button will be added to the Crop menu.
The
All button is a toggle that includes All, Pan, and Scan. Each work as in the
menu. Z operation of the joystick operates the All crop adjustment (works
similar to zoom), X and Y operates as Pan and Scan (
Figure 153).
Crop All and Crop Edges can be adjusted using the soft knobs (Figure 153).
Wipeipe
1
KeyKey
5
KeyKey
3
KeyKey
1
Wipeipe
2
KeyKey
6
KeyKey
4
KeyKey
2
Adel
9.000
Y
X
-9.000
Thru
50.%
Last
AlliDPM
ThruCropCPin
PGM Dlg
Dlg
8623267_29
T/L
T/R
B/L
X
Y
Thru
B/R
To Next Page
Loading...
