KAYENNE — User Manual 293
Copy/Swap
Figure 198. Copy Swap Timeline sub-level Selection
For example, ME2 Pri, Effect Register 1, has two keyers with iDPM param-
eter settings you want as part of an effect (Figure 198) but you want to use
those sub-levels with the parameter settings in Effect Register 0, on ME1
Pri. One way to accomplish this is to copy the Keyer/iDPM sub-level infor
-
mation of Effect ME2 Pri, Effect Register 1, to Register 0, on ME1 Pri:
1. Touch the From Effect Number data pad (Figure 198) and enter the effect
register number you want to copy ‘from’ in the Enter Source Register
pop-up keypad.
2. Touch the To Effect Number data pad (Figure 198) and enter the effect
register number you want to copy ‘to’ in the Enter Destination Register
pop-up keypad.
3. With the Include All Sublevels button off, touch the Keyer 3, Keyer 4, iDPM 3
and
iDPM 4 sub-level buttons to turn them on (alternatively, you can
turn on Include All sub-levels and individually touch each sub-level to
disable them).
4. Touch the Copy button.
5. Recall the destination register to see the result (touching the Copy
button does not trigger a recall).
The result is that only Keyer 3, Keyer 4, iDPM 3, and iDPM 4 are copied to
Register 0, on ME1 Pri. All other effect parameter settings are the same.
To Next Page
Loading...
