380 KAYENNE — User Manual
Section 3 — System Operation
Figure 235. Record Mode
When the Record Enable button is touched, ClipStore ejects the clip from the
selected channel, places the ClipStore channels in E/E mode, and displays
a pop-up keyboard. Type in the name of the new clip. Once the name is
typed,
Enter is pressed, and the keyboard closes, the Record Enable button is
highlighted red and the menu has changed to display recording controls
and parameters in readiness for recording (
Figure 236). The Play device
control button is replaced by a Record button.
Clips can be overwritten by entering an existing clip name into the pop-up
keyboard or by touching the
Cancel button in the pop-up keyboard and
touching a clip (or folder then clip) in the Folders/Clips menu (
Figure 231).
Once either operation is completed, you are returned to the Record mode
menu and the
Record button is present and highlighted in red.
Note Thumbnails do not display in the Current Thumbnail Viewer in Record Enable
mode except when overwriting an existing clip.
To Next Page
Loading...
