KAYENNE — User Manual 413
Image Store (Stills)
Figure 262. Position Menu
1. Touch the image you wish to re-position.
2. Touch the Position data pad to display the Position menu (Figure 262).
3. Touch the Horizontal (X) or Vertical (Y) data pads (Figure 262) and enter a
value in the keypad to change the image position, then press Enter, or
use the Menu Panel soft knobs to adjust the image position.
4. Touch the Confirm Position button to complete the change in position and
close the Position menu (
Figure 262).
Freeze Mode
Freeze Mode can be set to Frame, Field 1, or Field 2 using the Frame, Field 1
or
Field 2 buttons. This is very useful if you need to eliminate motion flicker
or artifacts from an image. To set the Freeze Mode (
Figure 263):
1. Touch an image from the scrolling list.
2. Touch the Freeze Mode button.
3. Viewing the image on a monitor, touch the Frame/Field 1/Field 2 buttons
to change the mode for the best image.
4. Touch the Confirm button.
To Next Page
Loading...
