KAYENNE — User Manual 99
Control Panel Overview
Introduced in Kayenne 2.0:
• Outlines have been added to border the display text; this is now the
default. Outlines can be toggled off/on in the MFM: from Home, press
the
Panl, Bri, buttons then toggle the OUTL (under Joystick) button.
• Inserting a space in the Source Name wraps the text to the second line.
For example typing
CAM then a space then the number 3 would wrap ‘3’
to the next line of the OLED button display.
The Source Module can be viewed as being in two sections; left for source
selection buttons, in groups of five, with SND (Source Name Display)
display and right, with function and delegation buttons (and one display)
for that ME (
Figure 76).
Source Select Buttons and SND
The following describes the Source Module organization for source select
buttons (
Figure 76):
• Source Selection buttons (left)—Can be mapped and delegated to
buses, macros, routers, etc. and there are no limits to mapping so the
same function or source can be mapped numerous times, and saved in
Panel Memory (Local E-MEM Module/File Ops, Panel Mem menu).
Source selection buttons can be mapped as:
• Switcher sources—Can be delegated to source selection for any
ME bus, Aux bus/Aux selection, Router control, Macros, or E-MEM
recall,
• Shift function—There are four shift levels 1st (unshifted), 2nd, 3rd,
and 4th,
• Row Delegation function—Mapped to the right-most source select
button (default). The SND (Source Name Display) associated with
the row delegation button indicates the name of the bus or function,
e.g. K2, MACRO, Router, U2, etc.,
• SND LEDs— SNDs have two modes, ‘Full’ and ‘Split’. If both adjacent
rows have identical text for a source, it is displayed in full, i.e. large text.
If the two rows have different text, the SND is split into two rows of
smaller text. SNDs show source names, macro names, router source and
router destination names, Aux bus numbers, etc.
• Shift buttons—Shifts can be mapped anywhere using the
User Prefs,
Button Mapping menu (default is 2nd and 3rd on the second and third
source select buttons from the right). Each ME row can have three
buttons labeled 2nd, 3rd, and 4th for shift levels or just 2nd 3rd (when
pressed together delegate to the 4th shifted level, the default), or none
at all and sources can be assigned to these buttons (no shift levels).
To Next Page
Loading...
Need help?
General
