GW Instek PEL-2000A Series - Page 175

OPERATION
175
Configure
OCP Function
Chan:
Active
Channel
SEQ
USB
OCP
On
06/15/18
16 : 50
Range:
Start C:
End C:
Step_C:
Step_T:
Delay:
Trig_V:
Keep_T:
1
0.05
0.000
0.0000
0.000
High
0.000
71.400
0.002
FRM
Last_C: 0.000
2. Use the Selector knob to
highlight the parameter you
want to edit.
3. Press the Selector knob to edit
the parameter, then turn to
increase or decrease the value.
OR
Use the number pad to enter a
number.
CAL.
987
3
CLEAR
21
0
4 5 6
P0 LOCK
P3P1 P2
P6P4 P5
P9P7 P8
4. Press the Selector knob or Enter
to confirm selection.
OR
ENTER
5. Repeat steps 2 -4 for all the parameters.
Save the OCP
Test Automation
Settings
6. Press Save (F3) to save the OCP
Test Automation settings.
F3