PEL-2000A Series User Manual
34
Static/Dynamic
Selector Key
The STATIC/DYNA. Key manually
switches the load from Static
(manual) to Dynamic loads.
Dynamic loads are only supported
in CC and CR mode.
For more information see page 62 &
65.
The Slave Knob is used to edit and
vary parameters for the active
channel on the local load.
Depending on the Mainframe
setup, the Slave Knob will either
only update the load (locally) or
will update both the local module
and the mainframe*. The Slave
Knob can also be configured to
display measured or set values on
the local load module**.
* For more information on “Knob
Type”, see page 215.
** For more information on “Slave
Knob”, see page 219.
The SHORT key is used to
manually short circuit the active
channel on the local active load.
The Short key can be set to enable
or disable in the configure setting.
Please refer to page 189 for details.
Load on: Pressing or holding the
SHORT key will short the load,
depending on the short type
selected.
To Next Page
Loading...
