GW Instek PEL-2000A Series - Page 80

PEL-2000A Series User Manual
80
As can be seen above, a trigger sequence signal is
output for every rising edge point.
Trig In
The Trigger In setting allows a sequence to start
after a trigger (Trig Out) has been received via the
frame link connector. The Trig In setting is used
for frame linked mainframes.
Channel Duration
Time Setting
The Channel Duration Time Setting feature allows
the point time duration of one Sequence to be
imported by another Sequence. If the receiving
sequence doesn’t have enough points, more will
be created (without values).
For example, the sequences for CH1 and CH2 are
shown below. CH1 has a total of 6 points with
long durations, whilst CH2 has only 2 points,
looped 5 times. The points from CH2 are also
significantly shorter in duration.
Time
Value
Time
Value
Point1 Point2 Point3 Point4 Point5 Point6
Point1
Point2
CH1
CH2
Below shows the resulting sequence when CH1
imports CH2. CH1 imports the duration time
settings and number of points from CH2, but not
the value data.