The step resolution range is dependent on the load
module and the range:
Max resolution: Module dependent, see page 197
Min resolution: Module dependent, see page 197
When short mode is on, the load unit can simulate
a short circuit.
Shorting can be individually set for each channel
when programming sequences.
To initiate a short circuit manually, the short key is
used. It can be used at any time during an
operation. It will not affect the settings. After a
short circuit has finished, the load unit will resume
the previous operation.
The short function can be set ON or OFF. When
setting to ON, the short key is enabled. When
setting to OFF, the short key is disabled.
The short key can be set to toggle or hold. When
pressed in toggle mode, shorts are toggled on and
off. When pressed in hold mode, the key needs to
be held to short the load.
The Short Safety can be used to set the short
operation mode. When setting to ON, the short
function must be used in the case of Load ON.
When setting to OFF, the short function can be
used directly.
To Next Page
Loading...
