HBM MGCplus - Page 254

System
Recording series of tests
254 A0534-30.0 HBM: public MGCplus
Mode
Configure start/stop conditions.
Off: Trigger inactive
Measurement level: The trigger condition is triggered when the
measurement signal exceeds/undershoots the level value.
Example:
Measured value level: less→ greater
Time
Level
Start of the recording program
Condition met
Example:
Measured value level: greater
Time
Level
Start of the recording program
Condition met
Trigger:
OK
Cancel
Start Trigger 1
Type:
Channel:
Mode:
Level:
Start Trigger 1 
Off 
1 
greater than 
0.000000% ... 0.000000% ...
Gross Signal:
Define trigger
Start Trigger 1
Start Trigger 2
Start Trigger 3
Start Trigger 4
Stop Trigger 1
Stop Trigger 2
Stop Trigger 3
Stop Trigger 4
Start sampling rate trg.
Stop sampling rate trg.
Off
Measured value level
Measured value band
LV1
LV2
LV3
LV4
External trigger