Hologic Panther System - Page 302

Panther System
®
Operator’s Manual
AW-17791-001 Rev. 002 (EN)
275
Appendix B. Processing Flags
Code Description Outcome
IT (1-3) Incubator 1-3
temperature was out of
range.
Contact Hologic Technical Support.
ITF (1-3) Incubator 1-3 dual
thermistors have
exceeded allowable
range.
Contact Hologic Technical Support.
IUO The worklist was
performed with an assay
that is for Investigational
Use Only and is not
FDA cleared for IVD
use.
Informational message only. No action
necessary.
LDF The MTU was not read
by the luminometer
because of a delay,
which may be due to a
hardware or software
problem.
MTU is invalid.
Contact Hologic Technical Support.
LDT The worklist was
performed with an assay
that was installed as a
lab developed test and
is not FDA cleared for
IVD use.
Informational message only. No action
necessary.
LPF Luminometer
positioning failure.
Contact Hologic Technical Support.
LSF Load Station heater foil
failure.
Contact Hologic Technical Support.
LWF Liquid Waste Container
full.
Contact Hologic Technical Support.
M The Sample barcode ID
was entered by
keyboard (not scanned).
Informational message only. No action
necessary.
Table 116. Assay Processing Flags (Continued)