Hologic Panther System - Page 309

Panther System
®
Operator’s Manual
AW-17791-001 Rev. 002 (EN)
282
Appendix B. Processing Flags
Code Description Outcome
SRRE Sample rack currently
being pipetted has been
removed.
Sample is invalid.
Contact Hologic Technical Support.
STL Sample Pipettor Tip
Loss.
Sample is invalid.
Contact Hologic Technical Support.
SW Kinetic data collection
failed or database fails a
test order integrity
check.
Sample is invalid.
Contact Hologic Technical Support.
TC The Chiller temperature
was out of range while
processing an MTU.
MTU is invalid.
Contact Hologic Technical Support.
UMTU An unexpected MTU
has been placed in the
luminometer.An
unexpected MTU has
been placed in the
luminometer or
fluorometer.
MTU is invalid.
Contact Hologic Technical Support.
URM2 The MTU barcode was
unreadable prior to
entering the
luminometer.The MTU
barcode was
unreadable prior to
entering the
luminometer or
fluorometer.
MTU is invalid.
Contact Hologic Technical Support.
VACF Vacuum system failure. Worklist or bracket is invalid.
Contact Hologic Technical Support.
VVFS The volume verification
check for TCR + sample
is either too low or too
high.
Sample results marked as Invalid.
Sample must be retested, or re-collected if
volume is too low.
Check all samples for adequate volume prior
to loading.
Table 116. Assay Processing Flags (Continued)