Configuration
114 UDC3500 Universal Digital Controller Product Manual 3/07
Function Prompt
Lower Display
Selections or
Range of Setting
Upper Display
Parameter
Definition
OUTPUT
OUTPUT—Represents the displayed controller
output in percent (%).
ATTENTION Also see CB OUT when using a
characterizer on the output value.
ATTENTION When Position Proportional Control is
configured as the Output Algorithm; OUTPUT
represents the actual Slidewire Position whether in
Automatic or Manual Mode. Should the Slidewire
input fail for any reason, the Auxiliary Output will go
to the value configured for FAILSAFE OUTPUT
VALUE in the Control Setup Group.
ATTENTION When Three Position Step Control
(TPSC) is configured as the Control Algorithm;
OUTPUT represents only the estimated motor
position, not the actual motor position.
SP
SETPOINT—Represents the value of the setpoint
currently in use (LSP1, LSP2, LSP3, RSP or CSP)
and is shown in the same units as those used by the
PV.
LSP 1
LOCAL SETPOINT ONE—Output represents Local
Setpoint 1 regardless of active setpoint.
RSP
REMOTE SETPOINT—Represents the configured
RSP regardless of the active SetPoint.
IN ALG1
INPUT ALGORITHM 1 OUTPUT—Represents the
output from input algorithm 1.
IN ALG2
INPUT ALGORITHM 2 OUTPUT—Represents the
output from input algorithm 2.
PV 2
PROCESS VARIABLE FOR LOOP 2—Represents
the value of the Process Variable for Loop 2.
CBOUTL2
CONTROL BLOCK OUTPUT FOR LOOP 2—
Output for Loop 2 as calculated by the control block
(such as PID A). When using one of the
characterizers, OUTPUT 2 is the output value for
Loop 2 after it passes through the characterizer. CB
OUTL2 is the control block output before it passes
through the characterizer.
To Next Page
Loading...
