Configuration
184 UDC3500 Universal Digital Controller Product Manual 3/07
The content of the Emails sent by this controller contains the Alarm that triggered the
Email, its settings and the current value (if applicable) of the monitored variable. For
example, the content of an Email triggered by Alarm 1 Setpoint 1 that is configured to
monitor Input 1 would look something like this:
Name: Alarm 1 SP1, Type: INPUT1, Event: HIGH/END, Value = 500.00,
Actual = 712.69
The content of an Email triggered by Alarm 2 Setpoint 1 that is configured to monitor
Digital Input 1 would look something like this:
Name: Alarm 2 SP1, Type: DIG IN1, Event: HIGH/END, Value = 0.00,
Actual = 0.00
ATTENTION
Instruments that do not have the Real Time Clock option will always send Email time-stamped
with the date that the Ethernet Software in the instrument was last modified. Instruments with
the Real Time Clock option will send Email time-stamped with the current time in the controller.
If the SMTP address on your network is changed, such as can happen when a server is
replaced, then you must reconfigure the Email SMTP IP address in this instrument to match.
To Next Page
Loading...
