3 BIOS/Platform Configuration Options
3.1 What's new in Gen10 Plus Snap 4?
3.2 Workload Profiles and performance options
3.2.1 Workload matching
3.2.2 Workload Profiles dependencies overview
3.2.2.1 Workload Profile Dependencies for Intel® Xeon® Scalable Processors
3.2.2.2 Workload Profile Dependencies for 1st and 2nd Gen AMD EPYC™ processors
3.2.3 Applying a Workload Profile
3.2.4 Changing dependent options after applying a profile
3.3 Changing System Options
3.3.1 Configuring Boot Time Optimizations
3.3.1.1 Setting Dynamic Power Capping Functionality
3.3.1.2 Enabling or disabling Extended Memory Test
3.3.1.3 Enabling or disabling Memory Fast Training
3.3.1.4 Setting the UEFI POST Discovery Mode
3.3.1.5 Enabling or disabling Memory Clear on Warm Reset
3.3.2 Configuring Serial Port Options
3.3.2.1 Assigning an Embedded Serial Port
3.3.2.2 Assigning a Virtual Serial Port
3.3.2.3 Mirroring serial console to a USB port
3.3.3 Configuring USB Options
3.3.3.1 Setting USB Control
3.3.3.2 Enabling or disabling USB Boot Support
3.3.3.3 Selecting the Removable Flash Media Boot Sequence
3.3.3.4 Enabling or disabling the Internal SD Card Slot
3.3.4 Configuring the IOS Serial Console and EMS
3.3.4.1 Enabling or disabling the BIOS Serial Console Port
3.3.4.2 Selecting the BIOS Serial Console Emulation Mode
3.3.4.3 Setting the BIOS Serial Console Baud Rate
3.3.4.4 Configuring EMS Console port settings
3.3.5 Configuring Server Availability
3.3.5.1 Enabling or disabling ASR
3.3.5.2 Setting the ASR timeout
3.3.5.3 Enabling or disabling Wake-On LAN
3.3.5.4 Setting the POST F1 prompt delay
3.3.5.5 Enabling or disabling momentary power button functionality
3.3.5.6 Setting the automatic power-on state
3.3.5.7 Setting the power-on delay
3.3.5.8 Setting the POST ASR
3.3.5.9 Setting the POST ASR Timer
3.3.5.10 Enabling or disabling the IPMI Watchdog Timer
3.3.5.11 Setting the IPMI Watchdog timer timeout
3.3.5.12 Setting the IPMI Watchdog Timer policy
3.3.6 Viewing and entering server asset information
To Next Page
Loading...
