120
Views
FTP client view
Predefined user roles
network-admin
Parameters
marker: Specifies the retransmission offset, in bytes.
Usage guidelines
Use this command to continue with a file retransmission. The file retransmission starts from the
(offset+1)th byte.
You can perform this operation only after you log in to the FTP server.
Support for this command depends on the FTP server.
Examples
# Set retransmission offset to 2 bytes and retransmit the h.c file. The file has 82 bytes in total.
ftp> restart 2
restarting at 2. execute get, put or append to initiate transfer
ftp> put h.c h.c
local: h.c remote: h.c
350 Restart position accepted (2).
150 Ok to send data.
226 File receive OK.
80 bytes sent in 0.000445 seconds (175.6 kbyte/s)
ftp> dir
150 Here comes the directory listing.
-rw-r--r-- 1 0 0 82 Jul 18 02:58 h.c
rhelp
Use rhelp to display the FTP commands supported by the FTP server.
Use rhelp protocol-command to display the help information for an FTP command supported by the
FTP server.
Syntax
rhelp [ protocol-command ]
Views
FTP client view
Predefined user roles
network-admin
Parameters
protocol-command: Specifies an FTP command.
Usage guidelines
You can perform this operation only after you log in to the FTP server.
Examples
# Display the FTP-related commands supported by the FTP server.
To Next Page
Loading...
