250
monitor cpu-usage threshold
Use monitor cpu-usage threshold to set the CPU usage threshold.
Use undo monitor cpu-usage threshold to restore the default.
Syntax
monitor cpu-usage threshold cpu-threshold [ slot slot-number [ cpu cpu-number ] ]
undo monitor cpu-usage threshold [ slot slot-number [ cpu cpu-number ] ]
Default
The CPU usage threshold is 99%.
Views
System view
Predefined user roles
network-admin
Parameters
cpu-threshold: Specifies the CPU usage threshold in percentage. The value range is 0 to 100.
slot slot-number: Specifies an IRF member device by its member ID. If you do not specify a member
device, this command sets the CPU usage threshold for the master device.
cpu cpu-number: Specifies a CPU by its number.
Usage guidelines
The device samples CPU usage at an interval of 1 minute. If the sample is greater than the CPU
usage threshold, the device sends a trap.
Examples
# Set the CPU usage threshold to 80%.
<Sysname> system-view
[Sysname] monitor cpu-usage threshold 80
Related commands
display cpu-usage configuration
password-recovery enable
Use password-recovery enable to enable password recovery capability.
Use undo password-recovery enable to disable password recovery capability.
Syntax
password-recovery enable
undo password-recovery enable
Default
Password recovery capability is enabled.
Views
System view
Predefined user roles
network-admin
To Next Page
Loading...
