260
Views
System view
Predefined user roles
network-admin
Parameters
slot slot-number: Specifies an IRF member device by its member ID.
hotspot: Configures temperature alarm thresholds for hotspot sensors. A hotspot sensor is typically
near the chip that generates a great amount of heat and used to monitor the chip.
sensor-number: Specifies a sensor by its number. The value range is 1 to 4. Each number
represents a temperature sensor on the device.
lowlimit: Specifies the low-temperature threshold in Celsius degrees. The value range varies by
temperature sensor. To view the value range, enter question mark ? in the place of this argument.
warninglimit: Specifies the high-temperature warning threshold in Celsius degrees. This threshold
must be greater than the low-temperature threshold The value range for this threshold varies by the
low-temperature threshold you specified.
alarmlimit: Specifies the high-temperature alarming threshold in Celsius degrees. This threshold
must be greater than the warning threshold. The value range for this threshold varies by the warning
threshold you specified.
Usage guidelines
When the device temperature drops below the low-temperature threshold or reaches the
high-temperature warning or alarming threshold, the device performs the following operations to
notify you:
• Sends log messages and traps.
• Sets LEDs on the device panel.
Examples
# Set temperature alarm thresholds for hotspot sensor 1 in a slot.
<Sysname> system-view
[Sysname] temperature-limit slot 1 hotspot 1 -10 50 60
Related commands
display environment
time at
Use time at to specify an execution date and time for a non-periodic schedule.
Use undo time to delete the execution date and time configuration for a non-periodic schedule.
Syntax
time at time date
undo time
Default
No execution time or date is specified for a non-periodic schedule.
Views
Schedule view
To Next Page
Loading...
Need help?
General