HPE FlexFabric 5940 SERIES Fundamentals Command Reference

85
undo telnet server dscp
Default
IPv4 uses the DSCP value 48 for Telnet packets sent to a Telnet client.
Views
System view
Predefined user roles
network-admin
Parameters
dscp-value: Specifies a DSCP value in the range of 0 to 63.
Usage guidelines
This command is not supported in FIPS mode.
The DSCP value is carried in the ToS field of an IPv4 packet to indicate the packet transmission
priority.
Examples
# Set the DSCP value for IPv4 to use for outgoing Telnet packets to 30 on a Telnet server.
<Sysname> system-view
[Sysname] telnet server dscp 30
telnet server enable
Use telnet server enable to enable the Telnet server.
Use undo telnet server enable to disable the Telnet server.
Syntax
telnet server enable
undo telnet server enable
Default
The Telnet server is disabled.
Views
System view
Predefined user roles
network-admin
Usage guidelines
This command is not supported in FIPS mode.
Users can Telnet to the device only when the Telnet server is enabled.
Examples
# Enable the Telnet server.
<Sysname> system-view
[Sysname] telnet server enable

HPE FlexFabric 5940 SERIES Specifications

General

Brand	HPE
Model	FlexFabric 5940 SERIES
Category	Switch
Language	English