EasyManua.ls Logo

HPE FlexFabric 5940 SERIES

HPE FlexFabric 5940 SERIES
289 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
129
TFTP packet transmission, make sure the interface is up and has the primary IPv4 address
configured.
• ip source-ip-address: Specifies an IPv4 address. For successful TFTP packet transmission,
make sure this address is the IPv4 address of an interface in up state on the device.
Usage guidelines
The source address specified with the tftp command takes precedence over the source address
specified with the tftp client source command.
The source address specified with the tftp client source command applies to all TFTP connections.
The source address specified with the tftp command applies only to the current TFTP connection.
Examples
# Download the new.bin file from TFTP server 192.168.1.1 and save the file as new.bin.
<Sysname> tftp 192.168.1.1 get new.bin
Press CTRL+C to abort.
% Total % Received % Xferd Average Speed Time Time Time Current
Dload Upload Total Spent Left Speed
100 13.9M 100 13.9M 0 0 1206k 0 0:00:11 0:00:11 --:--:-- 1206k
Writing file...Done.
<System>
Table 20 Command output
Field Description
% Percentage of file transmission progress.
Total Size of files to be transmitted, in bytes.
% Percentage of received file size to total file size.
Received Received file size, in bytes.
% Percentage of sent file size to total file size.
Xferd Sent file size, in bytes.
Average Dload Average download speed, in bps.
Speed Upload Average upload speed, in bps.
Writing file…
The system was writing the downloaded file to the storage medium.
This field is displayed only when the
get
or
sget
keyword is specified.
If the operation succeeded, this command displays
Done
at the end
of this field. If the operation failed, this command displays
Failed
.
Related commands
tftp client source
tftp client ipv6 source
Use tftp client ipv6 source to specify the source IPv6 address for TFTP packets sent to an IPv6
TFTP server.
Use undo tftp client ipv6 source to restore the default.
Syntax
tftp client ipv6 source { interface interface-type interface-number | ipv6 source-ipv6-address }
undo tftp client ipv6 source

Table of Contents

Other manuals for HPE FlexFabric 5940 SERIES

Related product manuals