HPE FlexFabric 5940 SERIES Fundamentals Command Reference

83
Examples
# Set the source IPv4 address to 1.1.1.1 for outgoing Telnet packets.
<Sysname> system-view
[Sysname] telnet client source ip 1.1.1.1
Related commands
display telnet client configuration
telnet ipv6
Use telnet ipv6 to Telnet to a host in an IPv6 network.
Syntax
telnet ipv6 remote-host [ -i interface-type interface-number ] [ port-number ] [ vpn-instance
vpn-instance-name ] [ source { interface interface-type interface-number | ipv6 ipv6-address } |
dscp dscp-value ] *
Views
User view
Predefined user roles
network-admin
Parameters
remote-host: Specifies the IPv6 address or host name of a remote host. A host name can be a
case-insensitive string of 1 to 253 characters. Valid characters include letters, digits, hyphens (-),
underscores (_), and dots (.).
-i interface-type interface-number: Specifies the interface for sending Telnet packets. This option is
required when the remote host address is a link-local address. When the server address is a global
unicast address, you cannot specify this option.
port-number: Specifies the TCP port number for the Telnet service on the remote host. The value
range is 0 to 65535 and the default is 23.
vpn-instance vpn-instance-name: Specifies the MPLS L3VPN instance to which the remote host
belongs. The vpn-instance-name argument represents the VPN instance name, a case-sensitive
string of 1 to 31 characters. If the remote host belongs to the public network, do not specify this
option.
source: Specifies a source IPv6 address or source interface for outgoing Telnet packets. If you do
not specify this option, the device uses the primary IPv6 address of the output interface for the route
to the server as the source address.
interface interface-type interface-number: Specifies the source interface. The primary IPv6 address
of the interface will be used as the source IPv6 address for outgoing Telnet packets.
ipv6 ipv6-address: Specifies the source IPv6 address for outgoing Telnet packets.
dscp dscp-value: Specifies a DSCP value for outgoing Telnet packets. The value range is 0 to 63.
The default is 48.
Usage guidelines
This command is not supported in FIPS mode.
To terminate the current Telnet connection, press Ctrl+K or execute the quit command.
Examples
# Telnet to the host at 5000::1.
<Sysname> telnet ipv6 5000::1

HPE FlexFabric 5940 SERIES Specifications

General

Brand	HPE
Model	FlexFabric 5940 SERIES
Category	Switch
Language	English