47
Press ENTER to get started.
3. Press Enter.
Pressing Enter does not start a session.
4. Press s.
A terminal session is started.
<Sysname>
authentication-mode
Use authentication-mode to set the authentication mode for a user line.
Use undo authentication-mode to restore the default.
Syntax
In non-FIPS mode:
authentication-mode { none | password | scheme }
undo authentication-mode
In FIPS mode:
authentication-mode scheme
undo authentication-mode
Default
In non-FIPS mode, the authentication mode is none for the AUX line.
In FIPS mode, the authentication mode is scheme.
Views
User line view
User line class view
Predefined user roles
network-admin
Parameters
none: Disables authentication.
password: Performs local password authentication.
scheme: Performs AAA authentication. For more information about AAA, see Security Configuration
Guide.
Usage guidelines
When the authentication mode is none, a user can log in without authentication. To improve device
security, use the password or scheme authentication mode.
In VTY line view, this command is associated with the protocol inbound command.
• If the settings of the two commands in VTY line view are both the default settings, the settings
for the commands in VTY line class view take effect.
• If the settings of the two commands in VTY line view are both non-default settings, the
non-default settings in VTY line view take effect.
• If only one command has a non-default setting in VTY line view, the other command uses the
default setting, regardless of the setting in VTY line class view.
To Next Page
Loading...
Need help?
General