88
A terminal display type change does not take effect for the current session. It takes effect for
subsequent login sessions.
Examples
# Set the terminal display type to VT100.
<Sysname> system-view
[Sysname] line vty 0
[Sysname-line-vty0] terminal type vt100
user-interface
Use user-interface to enter one or multiple user line views.
Syntax
user-interface { first-number1 [ last-number1 ] | { aux | vty } first-number2 [ last-number2 ] }
Views
System view
Predefined user roles
network-admin
Parameters
first-number1: Specifies the absolute number of the first user line. The value range is 0 to 73.
last-number1: Specifies the absolute number of the last user line. The value range is 1 to 73. This
number cannot be smaller than first-number1.
aux: Specifies the AUX line.
vty: Specifies the VTY line.
first-number2: Specifies the relative number of the first user line. The value range is 0 to 9 for AUX
lines and 0 to 63 for VTY lines.
last-number2: Specifies the relative number of the last user line. The value range is 1 to 9 for AUX
lines and 1 to 63 for VTY lines. This number cannot be smaller than first-number2.
Usage guidelines
This command is an older version reserved for backward compatibility purposes. It has the same
functionality and output as the line command. As a best practice, use the line command.
To configure settings for a single user line, use this command to enter the user line view.
To configure the same settings for multiple user lines, use this command to enter multiple user line
views.
Examples
# Enter the view of AUX line 0.
<Sysname> system-view
[Sysname] user-interface aux 0
[Sysname-line-aux0]
# Enter the views of VTY lines 0 to 4.
<Sysname> system-view
[Sysname] user-interface vty 0 4
[Sysname-line-vty0-4]
To Next Page
Loading...
Need help?
General