48
An authentication mode change does not take effect for the current session. It takes effect for
subsequent login sessions.
Examples
# Enable the none authentication mode for VTY line 0.
<Sysname> system-view
[Sysname] line vty 0
[Sysname-line-vty0] authentication-mode none
# Enable password authentication for VTY line 0 and set the password to 321.
<Sysname> system-view
[Sysname] line vty 0
[Sysname-line-vty0] authentication-mode password
[Sysname-line-vty0] set authentication password simple 321
# Enable scheme authentication for VTY line 0. Configure the local user 123 and set the password to
321. Assign the Telnet service and the user role network-admin to the user.
<Sysname> system-view
[Sysname] line vty 0
[Sysname-line-vty0] authentication-mode scheme
[Sysname-line-vty0] quit
[Sysname] local-user 123
[Sysname-luser-manage-123] password simple 321
[Sysname-luser-manage-123] service-type telnet
[Sysname-luser-manage-123] authorization-attribute user-role network-admin
Related commands
set authentication password
auto-execute command
Use auto-execute command to specify the command to be automatically executed for a login user.
Use undo auto-execute command to restore the default.
Syntax
auto-execute command command
undo auto-execute command
Default
No command is specified to be automatically executed for a login user.
Views
User line view
User line class view
Predefined user roles
network-admin
Parameters
command: Specifies the command to be automatically executed.
To Next Page
Loading...
Need help?
General