170
display this
Use display this to display the running configuration in the current view.
Syntax
display this
Views
Any view
Predefined user roles
network-admin
network-operator
Usage guidelines
Use this command to verify the configuration you have made in a certain view.
This command does not display parameters that are using the default settings.
Some parameters can be successfully set even if their dependent features are not enabled. For
these parameters, this command displays their settings after the dependent features are enabled.
This command can be executed in any user line view to display the running configuration of all user
lines.
Examples
# Display the running configuration on VLAN-interface 1.
<Sysname> system-view
[Sysname] interface vlan-interface 1
[Sysname-Vlan-interface1] display this
#
interface Vlan-interface1
#
return
reset saved-configuration
Use reset saved-configuration to delete a next-startup configuration file.
Syntax
reset saved-configuration [ backup | main ]
Views
User view
Predefined user roles
network-admin
Parameters
backup: Specifies the backup next-startup configuration file.
main: Specifies the main next-startup configuration file.