81
undo stopbits
Default
One stop bit is used.
Views
User line view
Predefined user roles
network-admin
Parameters
1: Uses one stop bit.
1.5: Uses one and a half stop bits. The device does not support using one and a half stop bits. If you
specify this keyword, two stop bits are used.
2: Uses two stop bits.
Usage guidelines
This command is not supported in VTY line view.
The configuration terminal and the device must use the same number of stop bits to communicate.
Examples
# Set the number of stop bits to 1 for AUX line 0.
<Sysname> system-view
[Sysname] line aux 0
[Sysname-line-aux0] stopbits 1
telnet
Use telnet to Telnet to a host in an IPv4 network.
Syntax
telnet remote-host [ service-port ] [ vpn-instance vpn-instance-name ] [ source { interface
interface-type interface-number | ip ip-address } | dscp dscp-value ] *
Views
User view
Predefined user roles
network-admin
Parameters
remote-host: Specifies the IPv4 address or host name of a remote host. A host name can be a
case-insensitive string of 1 to 253 characters. Valid characters include letters, digits, hyphens (-),
underscores (_), and dots (.).
service-port: Specifies the TCP port number for the Telnet service on the remote host. The value
range is 0 to 65535 and the default is 23.
vpn-instance vpn-instance-name: Specifies the MPLS L3VPN instance to which the remote host
belongs. The vpn-instance-name argument represents the VPN instance name, a case-sensitive
string of 1 to 31 characters. If the remote host belongs to the public network, do not specify this
option.
To Next Page
Loading...
Need help?
General