HPE FlexFabric 5940 SERIES Fundamentals Command Reference

271
Syntax
provision [ subslot subslot-number ] model model
undo provision [ subslot subslot-number ] model
Default
Preprovisioning is disabled.
Views
Slot view
Predefined user roles
network-admin
Parameters
subslot subslot-number: Specifies a subslot. The subslot-number argument represents the subslot
number. If you do not specify a subslot, preprovisioning is enabled on the slot. To specify a subslot,
you must first enable provisioning on the slot and make sure the provisioned IRF member device has
subslots.
model model: Specifies the model of the IRF member device or subcard to be preprovisioned. To
obtain available models, enter a question mark (?) for the model argument.
Usage guidelines
This command allows you to enable preprovisioning on offline modules, including subcards and IRF
member devices.
The device automatically creates interfaces when preprovisioning is enabled for a module. The
display interface command will not display these interfaces until the module comes online.
When you disable preprovisioning on a slot, the device removes all preconfigured settings for the slot,
including the preconfigured settings for the subslots.
When you disable preprovisioning on a subslot, the device removes preconfigured settings for the
subslot.
Examples
# Enable preprovisioning for the HPE FlexFabric 5940 2-slot Switch (JH397A) on a slot.
<Sysname> system-view
[Sysname] slot 2
[Sysname-slot-2] provision model 5940 2-slot
Related commands
display provision failed-config
reset provision failed-config
slot
reset provision failed-config
Use reset provision failed-config to clear preprovisioned-commands application failure records.
Syntax
reset provision failed-config
Views
User view

HPE FlexFabric 5940 SERIES Specifications

General

Brand	HPE
Model	FlexFabric 5940 SERIES
Category	Switch
Language	English