HPE FlexFabric 5940 SERIES

73
parity
Use parity to specify the parity.
Use undo parity to restore the default.
Syntax
parity { even | mark | none | odd | space }
undo parity
Default
The setting is none. No parity is used.
Views
User line view
Predefined user roles
network-admin
Parameters
even: Uses even parity.
mark: Uses mark parity.
none: Uses no parity.
odd: Uses odd parity.
space: Uses space parity.
Usage guidelines
This command is not supported in VTY line view.
The configuration terminal and the device must use the same parity.
Examples
# Configure AUX line 0 to use odd parity.
<Sysname> system-view
[Sysname] line aux 0
[Sysname-line-aux0] parity odd
protocol inbound
Use protocol inbound to specify the supported protocols.
Use undo protocol inbound to restore the default.
Syntax
In non-FIPS mode:
protocol inbound { all | ssh | telnet }
undo protocol inbound
In FIPS mode:
protocol inbound ssh
undo protocol inbound