242
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface-type interface-number: Specifies an interface by its type and number. If you do not specify
an interface, this command displays the key parameters of every transceiver module.
Examples
# Display the key parameters of the transceiver module in interface Ten-GigabitEthernet 1/0/1.
<Sysname> display transceiver interface ten-gigabitethernet 1/0/1
...
display transceiver manuinfo
Use display transceiver manuinfo to display electronic label information for transceiver modules.
Syntax
display transceiver manuinfo interface [ interface-type interface-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface [ interface-type interface-number ]: Specifies an interface by its type and number. If no
interface is specified, this command displays electronic label information for the transceiver modules
on all interfaces.
Examples
# Display electronic label information for the transceiver module on interface Ten-GigabitEthernet
1/0/1.
<Sysname> display transceiver manuinfo interface ten-gigabitethernet 1/0/1
...
display version
Use display version to display system version information.
Syntax
display version
Views
Any view
Predefined user roles
network-admin
To Next Page
Loading...
Need help?
General