89
Related commands
user-interface class
user-interface class
Use user-interface class to enter user line class view.
Syntax
user-interface class { aux | vty }
Views
System view
Predefined user roles
network-admin
Parameters
aux: Specifies the AUX line class view.
vty: Specifies the VTY line class view.
Usage guidelines
This command is an older version reserved for backward compatibility purposes. It has the same
functionality and output as the line class command. As a best practice, use the line class
command.
To configure the same settings for all user lines of a line class, you can use this command to enter
the user line class view.
The following commands are available in user line class view:
• activation-key
• auto-execute command
• authentication-mode
• command accounting
• command authorization
• escape-key
• history-command max-size
• idle-timeout
• protocol inbound
• screen-length
• set authentication password
• shell
• terminal type
• user-role
For commands that are available in both user line view and user line class view, the device uses the
following rules to determine the settings to use:
• A setting in user line view applies only to the user line. A setting in user line class view applies to
all user lines of the class.
• A non-default setting in either view takes precedence over a default setting in the other view. A
non-default setting in user line view takes precedence over a non-default setting in user line
class view.
To Next Page
Loading...
Need help?
General